Eden Navigator WP-100 Especificações

THE LEADER IN BASS AMPLIFICATION. World Tour Bass Guitar Pre-amplifier Covering Model WP100 Navigator Never Compromise™ ©02-01-2006

10 Stereo Post-EQ Effects Send/Return – These standard 1/4-inch jacks allow you to send and receive your signal to and from external devices. This eff

11 INITIAL SET UP Before turning your Navigator ON, you must first determine which mode of operation you wish to use. It is critical to the safety of

12 Once you’ve established that your unit is set to the correct voltage, set the Master Volume control to minimum (fully counter-clockwise). Set the t

13 The ratio is variable from very soft compression (fully counter-clockwise) to hard limiting (fully clockwise). The Compressor light will blink when

14 Slowly bring the Enhance control up while playing. If you turn it up close to 12:00 on the dial and still don’t have your sound, stop there. Return

15 Now, cut the Level control to approximately 3:00 and do the same thing. Repeat this process with the two remaining control sets. By the way, this

16 Frequency enhancement results from cabinet placement and room acoustics. A cabinet placed on the floor will have the lower frequencies boosted by a

17 We have designed our amplifiers to operate safely at 2 Ohms only because everyone else is doing it and some users expect it. However, we much prefe

18 Learn More – If you’d like to learn more about your Navigator (or about our company and its activities), we invite you to visit our website – www.e

19 My Favorite Settings Setting 1____________________________________________________ Setting 2________________________________________________

2 Bass Guitar Pre-amplifier WP100 Navigator OPERATION MANUAL Publishing Date 02-01-2006 FOREWORD Congratulations on the purchase of your new Eden Wo

20 My Favorite Settings Setting 5____________________________________________________ Setting 6_______________________________________________

3 Please read this manual in its entirety before operating your new amplifier. Failure to do so could result in misuse or damage. We’ve taken the time

4 FRONT PANEL FEATURES Input Jack – Designed to accept a standard 1/4-inch mono phone plug. For best results use a high quality shielded cable to con

5 Enhance Bypass Switch – disengages the Enhance control for a quick change in tone. The indicator to the left of this control will be lit when the En

6 Mode Selector Switch – Your Navigator can be operated in Stereo or Bi-amp mode. This switch allows you to choose which mode is used. Limit Switch –

7 IMPORTANT NOTE: DO NOT use this jack for a Mono Signal Send! It may be possible to damage the mono headphones inserted into this jack, as well as yo

8 USE ONLY THE SAME SIZE AND TYPE FOR REPLACMENT. Using a fuse with a different rating than specified is a VERY BAD THING and can cause damage to your

9 Main D.I. Outputs – These fully balanced stereo XLR outputs provide +16dBm maximum. They can be used to send a stereo signal to a mixing board or re