Eden HA2000 Especificações descarregar pdf (Página 33)

Extension Terminal alone with the

internal magnet switch being bypassed

or to use both of them together.

If you choose to have both of the internal

magnetic Switch and Extension Terminal

work together, then.

z When the protected door is being opened or

the enteral device is triggered, the Open

Contact is activated and will transmit a

violation signal

However The Open Contact will transmit a “Door

Closed” or “Restored Signal” only affer the protected

door

and the violated device being restored.



Appendix

I.ChangingtheBatteries

When the Control Panel is in Low Battery condition, it

will display a low battery fault message when any key

is pressed, with a two-tone beep to remind you the

battery needs replacement.

PROBLEM? 17

Do not HESITATE to call us via our assistance hotline (at the end of the notice). Our technicians will have the pleasure to

help you make a perfect installation.

To Change Battery:

z Disable tamper protection by putting the Control

Panel into Programming Mode.



) The Programming Mode will

automatically quit after 10 minutes if no

keys are pressed.

z Loosen front screw with a coin and hinge front

away from base.

z Remove battery compartment screws and lid.

z Remove the old batteries.

z Insert new batteries with alkaline replacements.

Before inserting the 4

battery:

z Press and hold down the “RESET BUTTON”

(that can be found as pointed below in the picture)

and put in the 4

battery at the same time. :

z Release the “RESET BUTTON”

z Replace battery compartment lid and front.



) Always use alkaline batteries as

replacements to ensure long service life.

II.ResetProcedure

1. Control Panel User and Master

Codes Reset

The Control Panel can reset all user and master codes

without resetting programmed parameters by the

following sequence:

Step 1. Disable tamper protection by putting the

Control Panel into Programming Mode.



) The Programming Mode will

automatically quit after 10 minutes if no

keys are pressed.

Step 2. Press the “S” key and then the “RESET

BUTTON” simultaneously.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40 41

Comentários a estes Manuais

Sem comentários

Eden HA2000 Especificações Página 33

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Eden HA2000